text.skipToContent text.skipToNavigation
install a
Rheem

MODEL NO: 8A0340
Rheem 5 Star 340 Stainless Steel Gas Water Heater
Suitable for outdoor installations, the Rheem 340SS has a 340L first hour capacity and is significantly lighter than traditional enamelled steel cylinder water heaters, for easier installation. With no anode required it can also reduce ongoing maintenance costs.

Features at a Glance

Capacity
155
No. of People
5
Energy Rating
5
Warranty
12 years
Features:
  • 5 Star energy efficiency
  • Stainless Steel Cylinder
  • 185L/hour hot water recovery1 enough for large families
  • 340L first hour hot water capacity1
  • Mains pressure – to service multiple hot water demands at once
  • Significantly lighter than comparable enamelled steel cylinder water heaters, for easier installation
  • No anode - saves ongoing maintenance costs
  • Natural gas
  • Australian Made
1First hour capacity is the storage capacity plus nominal first hour recovery rate at 45°C temperature rise using Natural Gas, based on a cold water temperature of 15°C.
 
Rheem Stellar Stainless Steel water heaters are not recommended for installation in some areas. Refer to the Stainless Steel Suitability Map for your state to see if Stainless Steel is suitable for your home. 
 
Warranty:
  • 12 year cylinder warranty*
  • 3 years labour on cylinder*
  • 1 year parts and labour warranty on all other components for domestic (non-commercial) installations*
*Warranty conditions apply
 

Running Cost Estimator

Running Cost Estimator Disclaimer as at 01/10/2023

Things that you should know about the Rheem Running Cost Estimator

The estimator is provided as a guide only to help you compare estimated running costs between various water heater types.

The estimator is based on Australian Standard AS5263, which relies on certain assumptions, such as an average daily load of 200L and 19 tap turns. Your situation and usage may be different to these assumptions, so the estimator may not match your actual daily loads and pattern of use.

Accordingly, the estimator cannot and does not purport to provide an accurate assessment of your yearly hot water energy bill. It does, however, allow a reasonable comparison between various water heater types based on Australian Standard AS5263 and average fuel tariffs used in the estimator.

Your state has been used to determine the temperature rise required to heat water from cold to a temperature of 65C, the applicable charge for the tariff type selected and the amount of solar savings.

Solar savings are based on Australian Government approved modelling for the type of solar water heater selected and the booster type. All electric boosted solar water heaters are modelled with a continuous tariff, but may be suitable for use on other tariff types depending on the model selected, your climate zone and the amount and usage pattern of hot water use.

Tariffs are current as at 9th March 2023 and represent an average price for the fuel type for the capital city in the state or territory, including GST.

Fixed charges, system access charges, delivery fees and any other fees and charges, including special rates and discounts are excluded from the estimator.

Energy consumption figures used are for a typical water heater within a category and do not reflect a specific model. Actual energy use may vary.

Heat Pump and solar water heaters may be suitable for Off Peak/Shoulder Rate tariffs depending on the type of water heater selected and the location. You should consult with your energy provider or installer before making any decision.